I recently successfully installed and Obi110 with Google voice as a secondary provider and my cable companies VOIP as the primary provider. I recently missed a call which went to my cable company's voicemail system where a message was left. Normally after a message is left/waiting my phone's/handset's indicator light would flash to indicate there was a message waiting, however, after installing the Obi110 there is no message indicator light flashing (once the Obi110 is utilized/connect with my exisiting Cablevision VOIP service). Is there a way to restore this connectivity/passthrough while utilizing the Obi110? Also will my phone line stutter tone like it did pre-Obi110 to indicate there is a message/voicemail on the Cablevision VOIP line? Is it possible to configure it to behave this way.
Settings for message waiting only exist in Voice Service > SP1 or SP2. As far as the stutter tone, if you press # on the phone it will connect direct to your voip dial tone with proper MW indication. Other than that I don't see a MW indication except for the SP lines.