Since Google Voice is going away, I am getting setup with Localphone with my Obi110 using the default SP1. I am able to receive calls fine, but cannot dial out using a phone attached to the phone port. I believe what I need is the correct digitmap (dial plan) configuration for the 'outbound call route' for the phone port (?). I have searched the forum and online for the correct configuration, but have had no luck. Any help would be greatly appreciated.
See the post from RonR which was on "dslreports.com",
http://www.dslreports.com/forum/r29200823-Outgoing-calls-on-LocalPhone-don-t-connect (http://www.dslreports.com/forum/r29200823-Outgoing-calls-on-LocalPhone-don-t-connect)
Out of curiosity, read the entire thread linked below, and...:
Quote from: bluechip on April 28, 2014, 03:47:08 PM
See the post from RonR which was on "dslreports.com",
http://www.dslreports.com/forum/r29200823-Outgoing-calls-on-LocalPhone-don-t-connect (http://www.dslreports.com/forum/r29200823-Outgoing-calls-on-LocalPhone-don-t-connect)
Not solved.
In fact, the OP last posted=>
QuoteStill no luck, and my outbound calls on LP actually seem worse. Now I'm getting many busy signals when dialing, an occasional recording that says "no response from service provider" when making a call that doesn't go through, and then other calls go through fine, and still others do the rings until someone answers and then it disconnects.
Not very encouraging in the direction of LP for Obi users...?!?
If you are dialing within the US and Canada the default dial plan should work.