Hello,
Could someone clarify about receiving 2 concurrent incoming calls on PhonePower, as advertised in the Approved Service Providers section of obitalk.com. I have an Obi202 device. Do I need a "cloned line" to receive 2 concurrent calls on the same number? Or do I just select both Phone 1 and Phone 2 for SP1 in Obi's PhonePower setup process to allow 2 calls concurrently?
i want to follow this thread so here is some info
I talked to PP and was told that if u know how to set up the SIP u can implement the cloned line - they just won't do it for u and won't support it on the GV xfer.
The cloned line allows 2 ppl to use the line at the same time. That would imply u have 2 phones connected to the OBI. Unless the OBI 100 has a 2 active pairs that isn't possible (the connector has 4 connections). U need a 200 series.
I don't know if that is the same as concurrent calls - probably is.
So the ? at this point is how to set up the SIP for concurrent calls?
and
Is the 2nd line supported on the OBI 100?
ok the spec sheet says that the OBI 100 does cuncurrent calls
so the only ? left is how to set up the OBI
Any update on this as I am contemplating switching to PP before the deadline?