Text only | Text with Images

OBiTALK Community

General Support => New to Using the OBi / VoIP => Topic started by: jhbObiForum on May 06, 2014, 05:21:20 AM

Title: switched to Phone Power from GV - now I have to dial area code for local calls
Post by: jhbObiForum on May 06, 2014, 05:21:20 AM
I just switched to Phone Power from GV  - now I have to dial area code for local calls.  How can I fix it so that I just dial 7 digits for local calls?

Thanks!

JB
Title: Re: switched to Phone Power from GV - now I have to dial area code for local calls
Post by: ProfTech on May 06, 2014, 09:52:03 AM
Most ITSP's require that you dial either 10 or 11 digits, however you can configure the Obi to do it for you if you only have a few "local" exchanges. In some large metro areas the list of area codes and / or exchanges might be too long to make it feasible. 
Title: Re: switched to Phone Power from GV - now I have to dial area code for local calls
Post by: jhbObiForum on May 06, 2014, 10:03:57 AM
I only have one area code.  How do I configure the Obi to do this?
Title: Re: switched to Phone Power from GV - now I have to dial area code for local calls
Post by: azrobert on May 06, 2014, 10:58:15 AM
Add the following rule to the Primary route DigitMap.
It's usually the ITSP Profile A DigitMap.

<1aaa>xxxxxxx

Where aaa is your local area code.
Rules are separated by a vertical bar.
Title: Re: switched to Phone Power from GV - now I have to dial area code for local calls
Post by: jhbObiForum on May 07, 2014, 01:45:56 AM
All set.
Thanks
Text only | Text with Images