hello... i m new to obi n using Obi110 in India
need help to set my dial plan. .. Tried many guides n also forum threads but can't get my work done. .
my existing config
using trunk group 1 as sp1,li
in outbound route for phone port, default line is trunk group1
what I need is
Dial any 7, 10 or 11 digit number starting with 2 to 0
If SP1 is live it should be pre pend with 0 & then dialed out. pause 2 to 3
seconds is ok
If SP1 is down, then it should be dialed as it is without any prepend
You said:
QuoteDial any 7, 10 or 11 digit number starting with 2 to 0
I interpreted that to mean starting with 0, 1 or 2.
The following are replacements for the outbound route and digit maps. Remove the default definitions.
Replace 911 with the Indian emergency number.
Dial **8 prefix to force the call out the Line port when SP1 is live.
There normally is a 30 second pause before the call is routed out the Line port when SP1 is dead.
The X_NoRegNoCall parameter eliminates the wait.
I did not allow for any other requirements.
I did not test this configuration.
TG1 definition:
List: sp1,li
DigitMap: (Mph)
Phone Port OutboundCallRoute:
{***:aa2},{(Mtg1):tg1}
ITSP A DigitMap:
(<0>[012]xxxxxx|<0>[012]xxxxxxxxx|<0>[012]xxxxxxxxxx)
Line DigitMap:
([012]xxxxxx|[012]xxxxxxxxx|[012]xxxxxxxxxx|<**8:>[012]xxxxxx|<**8:>[012]xxxxxxxxx|<**8:>[012]xxxxxxxxxx |911|<#:>)
Phone Port DigitMap:
([012]xxxxxx|[012]xxxxxxxxx|[012]xxxxxxxxxx|**8[012]xxxxxx|**8[012]xxxxxxxxx|**8[012]xxxxxxxxxx |911|***|<#:>)
Voice Services -> SP1 Service -> X_NoRegNoCall: Checked
I interpreted "2 to 0" to mean any number except 1.
(Think of a rotary dial phone.)
If the numbers begin with any digit except "1" do this:
TG1 definition:
List: sp1,li
DigitMap: (Mph)
Phone Port OutboundCallRoute:
{***:aa2},{(Mtg1):tg1}
ITSP A DigitMap:
(<0>[02-9]xxxxxx|<0>[02-9]xxxxxxxxx|<0>[02-9]xxxxxxxxxx)
Line DigitMap:
([02-9]xxxxxx|[02-9]xxxxxxxxx|[02-9]xxxxxxxxxx|<**8:>[02-9]xxxxxx|<**8:>[02-9]xxxxxxxxx|<**8:>[02-9]xxxxxxxxxx |911|<#:>)
Phone Port DigitMap:
([02-9]xxxxxx|[02-9]xxxxxxxxx|[02-9]xxxxxxxxxx|**8[02-9]xxxxxx|**8[02-9]xxxxxxxxx|**8[02-9]xxxxxxxxxx |911|***|<#:>)
Voice Services -> SP1 Service -> X_NoRegNoCall: Checked
Thanks drgeoff