I am wanting to replace a SPA-3000 with the Obi110, and I need to configure the line port to send all incoming calls to a VOIP address.
On the SPA-3000, all I have to do is set the dialplan for the PSTN line to:
(S0:account@voipprovider.com)
and it sends all incoming calls on the PSTN line to my VOIP account...
How do I do this on the Obi110?
I set the InboundCallRoute to account@voipprovider.com, but it doesn't send out the calls to my voip account...
If you have the target VoIP provider configured on SP1 or SP2, you can simply forward the call:
Physical Interfaces -> LINE Port -> CallForwardUnconditionalEnable : (checked)
Physical Interfaces -> LINE Port -> CallForwardUnconditionalNumber : SPx(account)
If you prefer to use the InboundCallRoute approach instead:
Physical Interfaces -> LINE Port -> InboundCallRoute : {SPx(account)}
If you don't have the target VoIP provider configured on SP1 or SP2, you will still need SP1 and/or SP2 configured as SIP. You can then forward the call using:
Physical Interfaces -> LINE Port -> CallForwardUnconditionalEnable : (checked)
Physical Interfaces -> LINE Port -> CallForwardUnconditionalNumber : SPx(account@voipprovider.com)
If you prefer to use the InboundCallRoute approach instead:
Physical Interfaces -> LINE Port -> InboundCallRoute : {SPx(account@voipprovider.com)}
Quote from: CapitolSheds on May 31, 2011, 06:59:13 AM
I am wanting to replace a SPA-3000 with the Obi110
We are seeing more and more of these comments. In the spirit of being Green, it looks like Obihai should be considering a recycling project for all these replaced units. :D