Print Page - How to modify the phone port parameters?

Title: How to modify the phone port parameters?
Post by: jc2516 on March 29, 2015, 10:18:00 PM

I purchased an OBI200 a few days ago, and I set up a GV on SP1 at obitalk.com. Now I want to change the digmap for Physical Interfaces. I change the Digmap, submit and reboot. After rebooting, the digmap is still the original. What should do to change it?

Thanks.

Title: Re: How to modify the phone port parameters?
Post by: azrobert on March 29, 2015, 10:36:41 PM

If you use the local interface to configure your OBi you must disable OBiTalk auto provisioning, otherwise OBiTalk will overlay any changes you make.

System Management -> Auto Provisioning
Under OBiTalk Provisioning
Method: Disabled

Title: Re: How to modify the phone port parameters?
Post by: lrosenman on March 30, 2015, 05:48:25 AM

The other option is to use ObiExpert from the portal to change parameters.

Then you still get ObiTalk advantages.

If you want to.

Title: Re: How to modify the phone port parameters?
Post by: jc2516 on March 30, 2015, 08:29:42 AM

Thank you both. I will try.

OBiTALK Community

General Support => New to Using the OBi / VoIP => Topic started by: jc2516 on March 29, 2015, 10:18:00 PM