Quote from: echen on January 29, 2013, 07:37:57 PM
I just want to send the call to local land line numbers (any local numbers accepted) which similar I was located at China office and dial out land line numbers.
So in this case, any suggestion for setup and information I can review?
Edit: I didn't see azrobert's response before I posted.
To setup what you wish to do would require some cut and try testing to get it right and you would need to be able to configure both the local and the distant OBi. If you are new to the OBi there will be a learning curve. I would think it would be helpful if you had an adapter to try things out on without disrupting your phone system.
Without testing anything to see if I'm mistaken, I think my general implementation approach would be the following. I am assuming you are using your HK mobile phone and calling a local pstn number that is attached to the PSTN Line port of your HK OBi110. If it is a voip number, then it is the same approach except you would be dealing with the InboundCallRoute of the SPx that has the voip DID.
1. Setup the incoming pstn line on the HK OBi110 so that a call from your mobile phone would send the call to the Automated Attendant (AA) IVR. This is done on the Line Port InboundCallRoute.
2. The AA will ask you to enter 2 to "Make a new call" and then ask you to enter the number. You would then enter some code that signals that this is a China LandLine number followed by the number.
3. You would setup the Automated Attendant (AA) DigitMap to allow this call with this code and then the Automated Attendant (AA) OutboundCallRoute to route the call with this number thru a VoiceGateway (VGx) that would send the call to the China OBi110 using the OBiTalk network.
4. You would setup the VoiceGateway that would send the call to the China OBi110 along with the number that you have dialed sending the call over the OBiTalk network.
5. On the China OBi110 you would setup the OBiTalk InboundCallRoute so that when it receives a call from the HK OBi110 that has a number dialed in the format you setup the InboundCallRoute would dial that number on the attached PSTN local line.