I have had my OBI 100 for approx 3 days and it was extremely easy to setup and was working right out of the box. This morning I tried to make a call from it and nothing. I noticed the phone said no line on the screen of the phone. These are the steps I took trying to diagnose the problem.
1. Unplugged the Obi 100 for 2 minutes and plugged it back in(essentially rebooting the device).
2. Logged into my router and looked for the ip of the obi(couldnt find it)
3. Tried to ping the ip I used the day I got when I updated the firmware. 100% packet loss on that ip. Didnt figure that would work anyway due to the fact that there was no obi 100 on my local area network.
4. Tried a full power cycle of all devices. Modem, Router, and Obi 100.
5. Changed out new ethernet that came with the obi 100, and changed the telephone line.
I do not believe there is any other step I can take to remedy my situation. I simply cannot connect to the obi 100 through my network.
The lights on the obi 100 blink like this, the red power light stays on for about 7 seconds, then I can see the router blinking the port I have the obi 100 connected to, and then the red power light comes back on the obi for about 5-7 seconds, then the router blinks the connected port for a few seconds, then the power light on the obi 100 again. The middle ethernet light on the obi 100 blinks green for a fraction of a second on the obi after the red power light turns off.
Can anyone think of anything else I can possibly try to get this to work before doing a RMA.