I don't want you to have to make a career of helping me, and I appreciate all of the help. First I have snooped into the NID (had to look up NID - the box outside!). That takes care of that. Only two of the four incoming wires go to any house wires, the other two are sitting not attached. There are not any RJ11's other than for a testing plug in so I can't easily do things in the NID. Now on to: Wow, thanks for pointing out those Three-ways, and even getting the good pricing for me. I actually had three Three-ways lying around, with one being that two line type. I had looked at them to see if they were 2 or 4 wire type, and I had assumed (!) they were just straight three way splitters until I looked closer. I saw how one outlet said L1+L2, but I missed that the others were not the same line (i.e. L1 and L1), they are one of each of the line pairs L1 and L2. They send their outputs to a standard phones two center terminals. So this splits up the lines for me. The L1 hole is for my modem and I use the L2 slots for my phone wiring. Those Three-ways you recommend will allow me to use that alternate pair house wiring for my phones and Obi output. I was already planning for some cords that I was going to cut and splice, these do that for me. I just ordered two more of them that I will need. I need one for the modem/Obi connections, and two for the wall outlets that I use. I will also have to make sure that all four of the wires are connecting to each jack for this configuration. I'll reply back later in the week when I get this going. Hopefully this is helping some others, but hopefully will not get them to attempt something that is outside their knowledge or fry an Obi. Thanks Shale.