Quotedemanding wife trying to get me of the computer
I know what that is like. LOL
After a number is dialed the Phone Port DigitMap gets control.
If the number matches a rule it is validated and it is passed to the OutboundCallRoute.
If the number doesn't match a rule, it will fail and you will get a Busy tone.
The DigitMap analyses the number as it's being dialed.
If the dialed number matches rule "011xx." there will be a 10 second delay.
"x." will match zero or MORE digits.
The DigitMap doesn't know if you are going to dial additional digits, so it waits.
Change the rule to "011xx.S3" and the delay will be 3 seconds.
You need a delay.
This delay only occurs in the Phone Port DigitMap processing.
OutboundCallRoute:
Processing moves left to right.
If the dialed number matches an ITSP DigitMap it is routed to the specified destination and processing stops.
If the dialed number doesn't match any ITSP DigitMap, you will get an IVR message something like "No routes available".
If the Phone Port DigitMap was coded correctly you should never get this message.
905|289|647|416|519|613|705|807 numbers with or without country code will be routed to SP1. Country code will be removed.
860 and 407 numbers plus all other 11 digit numbers not included in the SP1 list, will be routed to SP2.
1[2-9]xx[2-9]xxxxxx will match any 11 digit number.
10 digit numbers not included in the SP1 list, will be routed to SP3.
<1>[2-9]xxxxxxxxx will match any 10 digit number and add a "1" prefix.
<00> will also add a "00" prefix.
1xxxxxxxxxx will NEVER be used because 11 digit numbers will be routed to SP2.
This is probably a mistake.
I make plenty of mistakes and typos.
The best way to proceed is just try the above configuration and see what happens.
You can't break anything.
The worst that can happen is the call will be routed to the wrong provider.
Look at the OBi Call History to make sure the call was routed correctly.
To access Call History:
Log directly into the OBi using the local interface.
Key the IP address of the OBi into a Web Browser.
Hit Enter
The UserID and default Password are both "admin".
Click Status on the left column.
Then click Call History.