QuoteWhy does my attempt to route the call to the unused line port not work? Is it possible to route to the line port in such a manner as to deliberately cause a call failure and have the OBi110 generate a SIT tone?
It's basically the same scenario as routing the call to nowhere. GV is forwarding the call to your OBi110. If the forward fails or not answered, it will be sent to VM. A forked call will continue to ring your cell if the other leg fails.
Auto Attendant Setup:
Voice Services -> Auto Attendant
Under Auto Attendant Prompts set the following.
Menu: %User1%
%User1% will point to custom prompt#1.
All Other Prompts set to: &pause()
&pause() is the equivalent of deleting the prompt.
OutboundCallRoute: {}
AnswerDelay: 0
Voice Services -> SP1 Service -> X_InboundCallRoute:
{(MTelemarketers)|?:aa},{ph}
Record a custom prompt:
Dial the following:
***0
1001# This will save the recording to %User1%.
1002# will save to %User2%
1 This is for a new value for the recording
1 Any digit will start the recording
Say your custom message
# Will end the recording. Leave a couple of seconds
of silence at beginning and end.
1 Confirm the recording and save
Instead of saying the custom message, hold the phone next to the computer speaker and play Toaman's suggestion from Wikipedia.