Hi. I have an objective I want to run by the forum.
My setup is a Obi202 and 3 Obi1062's. I also use a generic Panasonic wireless phone system connected to Port 1 of the Obi202. The Obi1062's are connected wirelessly through my ethernet wireless home network.
I also have a gate keypad Liftmaster EL1SS. The EL1SS can directly access the home phone and speak to the homeowner. The homeowner can then open the gate with a *9 command. You can also request the EL1SS to call forward to an outside line with a series of commands. This is for use when you are away from home. The only real issue with call forward is that the called phone user must hit a 0 to be able to speak to the person at the gate. The EL1SS has two ring and tip 2 phone wire connections. The first goes directly to the phone system in the home. In this case, I am using some generic Panasonic wireless phones. The other line goes out the the Telco which I connected to Port 1 on the Obi202. I have it all hooked up and it works as it is supposed to.
However.... I cannot figure out how to get the Obi1062's to operate as part of the local phones. In other words, I would like to have the Obi1062's also ring (like the Panasonic system) when a person is at the gate. Then (like the Panasonic phones) have the person on the 1062 hit *9 to open the gate.
I thought that there might be a way to use Port 1 and Port 2 collaborate with each other to solve the issue. Bear in mind, however... the EL1SS cannot be programmed to dial any extra phone codes than what is was programmed to do.
Any ideas would be greatly appreciated.