At this point, I am not sure what to do.
I have tried the suggestions give by Everton.. Still doesn't want to register.
At this point, I think the one that will be of most help, and probably the only one that will help is to hear from someone who has actually registered an getonsip sip registration. Their website is
www.getonsip.comOf course if Obihai would add Onsip to one of the supported SIP providers and provide a named configuration page that would help too.
Again the problem seems to be is what to enter in each of the fields although I seem to have all the information.
For username I have the following options:
username,
username@getonsip.com, getonsip_username
For ports I am not sure whether to enter: 5060 or 5061 (above one of them is marked as 5061)
Not sure what to enter for or if to enter anything for: Service provider proxy server
Outbound proxy server: I am entering
sip.onsip.com (this one appears to be correct)
I have pretty much exhausted all possible combinations at this time.
-------------------------------------------------
Okay.. this is the update I have..
I downloaded X-lite
I also downloaded the Obi-PC App. (apparently this is needed; not sure of the mechanics)
I ran the Obi-PC App; I also fired up the X-lite
I entered my Onsip credentials into the X-lite config.
Voila.. I am able to receive calls made to the number I registered with ipKall, which links to the onSIP registration. The call rings in X-lite and I am able to talk/hear both ways.
So that is a massive improvement and kind of validates a lot of things.
But, still I am not able to make outgoing calls from X-lite.
The problem of being unable to configure SIP-2 using the On-SIP credentials on the Obi box still very much remains.
====================
After mulling over it a bit, I realized that Obi PC-App wasn't doing anything at all in my case, as the X-lite is connecting directly to the SIP service provider. I feel really stupid... I logged out of Obi-Pc-App and exited it, and everything else worked as before..
I also realized that I am not able to make outgoing calls because OnSIP doesn't provide for dialing PSTN numbers. It appears dialing SIP addresses works fine as I dialed my own address, and the call is looping back and I show an incoming call which I can attend, and my original call is put on hold!! Pretty cool, but right now practically useless! :=)
BACK TO SQUARE 1. The root topic of this forum.. configuring Obi Box to set up the SIP provider (OnSIP) that is failing.. Any help would be appreciated. Thanks.
====================