First off thank you for the reply. Sure has put me to thinking.
Sorry I meant the voice mail associated with my sip [main account].
I have two lines in my ring group 1. sip [main account] 2. FWD [cell phone number] each one is set for 20s. In my ring group the voice mail is associated with my SIP [main account] ring time in seconds for my
VoIP.ms DID is 20s.
My failover option is set for my
VoIP.ms is Route on no answer.
Sorry I don't know that the two beeps are coming from the OBi equipment. What is happening is: using a telephone exterior to the OBi system I call my DID. The telephone attached to the OBi equipment does not ring but my wife's cell does. In the earpiece of the exterior telephone there is silence then after 20s their are two beeps in the earpiece of the exterior telephone and the cellphone will start to ring again for another 20s then switches to the voice mail associated with the SIP [main account]
If you call my wife's cell phone directly it will ring and switch to her voice mail after 20s. In the config above the SIP [main account] is FWD to my wife's cell after 20s. Then rings for 20s and transfers to SIP [main account] voice mail.
If I change back to SIP [main account] the phone connected to the OBi equipment does ring.
I apologize for this long explanation I have rewritten this a half dozen times.
Any ideas would be greatly appreciated thank you.
Regards Bill