ObiBT with IP Phone

[mrjoe]

Well I never!!!

That is great!

Thanks so much

Do you use Action URLs?

[mrjoe]

This does not bother me that much but I have a Speed Dial set to: sp4(Snom320@local_client) it calls the Snom but audio from the mic of the Snom is not passed through to the earpiece of the phone attached to the Obi.

I don't really use it for incoming but would like to try to find out what the issue is.

Thanks

[mrjoe]

X_InboundCallRoute for the Proxy SP is: {Snom320>(<#:>):ph,ph2},{Snom320>:bt}

Pressing # on the Snom rings through to the Obi's phones and Audio is fine both ways.

[mrjoe]

MOH seem to be broken now, any idea how to get it working again on this Version?

EDIT: works with some identities not others, with newer firmware worked with all.

[mrjoe]

Fixed for Outgoing: Behavior > Call join on Xfer (2 calls): On

Default must have been changed to Off

Can't think how to get it to work for incoming...

EDIT: Hold Failure 599 after a few seconds and cutoff

[sinergy]

I havent got around to test call trans yet. Ill play with it this week. For my use Ill never use it. Got the obi as a line for my radio show.

Looking at moh


"Do you use Action URLs?"
I have played with them in the past on 7. I get to lazy to be honest.

[sinergy]

how are you doing moh? I can stream vlc to it. Its a feature I wont use on this line as they will hear my show and commercials Ill mute them on my mixer board.


Try sitting this to off http://wiki.snom.com/Settings/holding_reminder
see if that fixes your other problem

Looking through that was a bug in older code should have been fixed by this one