Cool, it's working (both local and mobile phones are ringing).
BTW, for the next guy who gets stuck, when you change these settings, you may need to change them thru
ObiTalk.com (in Expert Settings) and not directly over LAN to your OBi device....
I had big issues with this (settings sometimes would and other times wouldn't get saved!). See
http://www.obitalk.com/forum/index.php?topic=1503.0 for another guy's story.
Summary of actions (note, my default phone and SP phone are "Phone 2" and "SP2" (provider "B"), respectively, and that is visible in your device's
Obitalk.com settings.
1. Modified my SP2 phone's
DigitMapIn
obitalk.com go to Expert Settings for your device, find Service Providers > ITSP Profile B > General Settings (uncheck both checkmarks, then paste this line and save:
(0xxxxxxxxx|0xxxxxxxxxxx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)
It appears the first two make it possible to call city and mobile phones (0x 5555 5555 and 0xxx 5555 5555) in my area.
At first I pasted the additional part outside of the left parenthesis - I took the advice to paste the addition at the beginning too literally!
2. Modified my Phone2's
OutboundCallRouteI had one failure where I incorrectly modified DigiMap as I was trying to figure this out based on
http://www.obitalk.com/forum/index.php?topic=1792.0 and also Felix mention "digit map" so I simply strayed away.
In
obitalk.com go to your device, go to Expert Config > Physical Interfaces > Phone 2 > Outbound Call Route (uncheck the both checkmarks, then overwrite the default and save). In my case the first two 886's are my country code.
{(<0:00
886>xxxxxxxxx):sp2},{(<00
886>0xxxxxxxxxxx):sp2},{([1-9]x?*(Mpli)):pp},{(<#:>):ph1},{(<**82:>(Mbt2)):bt2},{(<**81:>(Mbt)):bt},{(<**8:>(Mbt)):bt},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**3:>(Msp3)):sp3},{(<**4:>(Msp4)):sp4},{(<**9:>(Mpp)):pp},{(Mpli):pli}
3. It seems each save action will make
obitalk.com push the new settings to your device and reboot it. To be on the safe side I waited 5 minutes between the changes as I didn't want to have any unexpected situations with settings not taking effect.
Thank you for your help and hope this helps others in a similar situation!