Australia OBi Device Configuration:When using the OBi device in Australia, please configure the following parameters as described below:
OBi110 & OBi100:Voice Services - SP1 Service - X_RingProfile:
BVoice Services - SP2 Service - X_RingProfile:
BVoice Services - OBiTALK Service - X_RingProfile:
BPhysical Interfaces - Phone Port - Port settings: Impedance:
220+(820||115 nF)Physical Interfaces - Phone Port - Calling Features - ToneProfile:
BOBi110 Only:Physical Interfaces - Line Port:
- RingProfile:
B- ToneProfile:
BPhysical Interfaces - Line Port - PSTN Disconnect Detection – DisconnectTonePattern:
425-30;4;(.375+.375)Physical Interfaces - Line Port - Port Settings:
- ACImpedance:
220+(820||120 nF) and 220+(820||115 nF) - OnHookSpeed:
26 ms (Australia) - TipRingVoltageAdjust:
3.2 V - MinimumOperationalLoopCurrent:
14 mA- DTMFPlaybackLevel:
-10Physical Interfaces - Line Port - Ring Detection:
- RingFrequencyMax:
70- RingThreshold:
13.50 – 16.50- RingValidationTime:
256Note: To make these changes, you will need to access the OBi unit's configuration using one of the following methods;
OBiTALK - OBi Expert Configuration (Recommended)
1. Log-in to
www.obitalk.com2. Select the OBi device to be configured.
3. Select
OBi Expert Configuration and then
Enter OBi Expert.
4. Use the left-side navigation menu to expose the configuration settings sections as described above.
5. Un-check
both the OBiTALK Settings & Device Default boxes
6. Configure the parameter as described above.
7. *Important* Select
Submit before you move to a new configuration section / page.
OBi Device Management Web UI1. Access the OBi device management web UI buy pointing a browser at the OBi's IP address.
- Dial ***1 from the attached phone. The IP Address will be read to you.
- Enter the IP address in the web site address / navigation window & select enter.
- When prompted, enter 'admin' for user name and 'admin' for password. Note: The password may have been previously changed. If this is the case, use the current admin password. You may need to log-in to OBiTALK to see the changed admin password. But if you do this, you might as well use the recommended method: OBi Expert Configuration.
2. Use the left-side navigation menu to expose the configuration settings sections as described above.
3. Configure the parameter as described above.
4. *Important* Select Submit before you move to a new configuration section / page.
Additional information, discussion and feedback may be found on the
www.Whirlpool.net.au forum.
...