On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT
OBi2182
OBi1022
Poly D230
OBi200
OBi202
OBi212
OBiWiFi5G
Started by PandaTW, February 08, 2014, 09:10:04 PM
Quote from: azrobert on February 08, 2014, 10:35:04 PMThe factory default for the OBi110 is the PSTN line.That means the following:When you take the phone off hook you hear dial tone from the OBi110.After you dial a number like 5551212, it is routed out the PSTN line.If you want to be connected and hear dial tone from the PSTN line when the phone is taken off hook:Add <S2:#>| to the beginning of Physical Interfaces -> Phone Port -> DigitMapIt should look like this:(<S2:#>|......defaults......)The above will automatically dial # if nothing is dialed after 2 seconds.If you want to route something to SP1 you have to start dialing **1 before 2 seconds.If that is not enough time then change the above rule to S3.
Quote from: drgeoff on February 09, 2014, 02:32:12 AMazrobert has given a good answer.Why did {ph} not work? {ph} specifies the PHONE port. You never want to use that in the PHONE port's OutboundCallRoute. When you want to specify the PSTN port in an OutboundCallRoute you can use {li}.