Help!!!
My OBI110 is in a reboot loop. I made a change via the web page and when I clicked on reboot the device rebooted and the LEDs turned green. In about 15 seconds the device reboots again and it keeps repeating this sequence. The phone is dead.
Here is the sequence of everything I did:
I updated the firmware.
Tried to configure GoogleVoice with the web wizard, but it wasn't working. I switched to a different computer and I finally got it to update the configuration, but the status showed it not configured.
I then manually configured SP2 for a generic SIP provider. It registered and I successfully made an outgoing call.
I registered to Obitalk and configured GoogleVoice via Obitalk. GoogleVoice connected and I successfully made an outgoing call. Obitalk showed SP2 as "not configured", but it was registered and working.
I logged back in to the web page and changed ITSP DIGITMAP. I created a notepad file on my computer and did a cut and paste.
This is what I changed it to: (1[2-9xxxxxxxxx|[2-9]xxxxxxxxx|<480>[2-9]xxxxxx.|xx.)
There are 2 mistakes. The first parm is missing "]" and the third has a ".".
When I clicked save and reboot is when the OBI110 went into a loop.
Is there a way to reset to factory defaults?
Update:
I found the factory reset button on the bottom of the unit. I pressed the button with a paper clip for 10+ seconds and it's still in the reboot loop. Tried it several times. Even held the button down and then powered up the unit.
It looks like it's dead.