Hi.
First off, thanks for your advise
(*) What softphone are you using?
Answer: Zoiper 3.6 for Windows 7
(*) The softphone will have to be able to call without registration.
Answer: Right. I have two SIP accounts. OBi110 is registered in one of them. The Zoiper softphone in the other one.
(*) Is that the URI to call your account at Anveo?
Answer: the SIP URI has this format:
1234567890@sip.anveo.com, where "1234567890" is a ten digits account number. Let's say
xxxxxxxxxx@sip.anveo.com is the softphone. Let's say
yyyyyyyyyy@sip.anveo.com is the OBI. When calling from softphone to OBI, I dial "sip:yyyyyyyyyy@sip.anveo.com" (without the quotes). The OBI rings for ever and ever. No AA showing up... keep reading!
(*) I think you have to use port 5010 for inbound SIP calls.
Comment 1: In fact, OBI expert > Status > system status > sp1 service status > status := Registered (server=72.9.149.69:5010; expire in 141s).
So you're right, port is 5010
Comment 2: In Anveo's web site I found: "Proxy server:
sip.anveo.com. Note, DNS_SRV is supported. Proxy port: 5010 (only use if your SIP device does not support DNS_SRV)". I don't know if OBi110 supports DNS_SRV.
(*) The UserID on the softphone will be seen as the CallerID. Then change your X_InboundCallRoute: {Your_Softphone_UserID:aa(+12223331234)},{ph}
Comment:
I tried Voice service > sp service > X_InboundCallRoute := {xxxxxxxxxx:aa(+12223331234)}. Result: OBI rings, no AA callback.
I tried Voice service > sp service > X_InboundCallRoute := {xxxxxxxxxx:aa}. Result: OBI rings, no AA answer.
I tried Voice service > sp service > X_InboundCallRoute := {('xxxxxxxxxx@sip.ca.anveo.com'):aa} Result: OBI rings, no AA answer.
I tried Voice service > sp service > X_InboundCallRoute := {(xxxxxxxxxx@sip.ca.anveo.com):aa} Result: OBI rings, no AA answer.
EVEN THIS I tried, Voice service > sp service > X_InboundCallRoute := aa Result: OBI rings, no AA answer.
I am speechless
What else could I try? What free softphone do you recommend? -- at least to perform some tests.
Final note, I did my homework, I read "OBi-DigitMapCallRoute-Tutorial-v1-1.pdf" so I am familiar with the formatting, but I am not an expert (as you can see
)
Any help is greatly appreciated.