ianobi, I hearby promote you to Mr. Wizard, if you weren't already at that exhalted level. Thank you very much.
Works perfect, after very strange wierdness.
I set back to defaults phone digitMap and outBoundCallRoute, set itspA and Line as shown. I might get one test call thru, then it would reboot on its own(power led would go red for a while). Then the SP1 authUserName would revert back to check, with box grayed out and blank. Password would still be set. Status showed SP1 not configured. After noticing that it was spontaineously rebooting, I did a power cycle(10 sec off). Still had the problem. Power cycled for a minute, and moved to a different outlet. Still was misbehaving. Did a full set to factory default. Entered google name and pw, itspA dm and line dm, and works wonderfully. Almost as if my disabling obitalk po'd it.
Calling from it to my GoogleVoice # is nearly instant, I was getting quite used to slow call setup and connect.
I also realize I have a whole lotta learning to do on these. I had been meaning to go back to my obi100 and do some house cleaning, but as it is my only phone, I will definately be buying a backup/spare before I start.
If you or anyone cares to field a question - it appears to me now that the outbound call route just blankets everything, and the digitMap at the termination(am I using that right) actually determines the outbound route??
Question 2(do I get 2?) in the following snippet of the default outboundCallRoute
{(<**1:>1xxxxxxxxxx| does this match **11xxxxxxxxxx as well as 1xxxxxxxxxx and if **1 is present delete it? I understood the delete part, but was unaware that it would match if the **1 weren't there.
Answered this one myself(patting self on back)
(1 xxx xxx xxxx) is working syntax, put it in itspA and test call works fine. I had noticed this in places, and it is so much easier than counting x's!
Thanks again,
mtncbn