hi,
i did have an Obi110, and took infin8loop's advice in an earlier topic last month in the Feature Request Forum (
http://www.obitalk.com/forum/index.php?topic=6330.msg40153#msg40153). infin8loop's advice was that if I want to turn off SP1 (so that I can dial out using Google Voice, from phone links in my Chrome, and/or receive calls in on my Chrome), then I could use the IVR and set some speed-dial buttons on my phone device so that I could quickly Enable/Disable line 1 (SP1). Like this: Suppose my password was 3333. So it would look like this to ENable SP1:
***0 100# 3333# 100# 1 1# 1
and like this to DISable SP1:
***0 100# 3333# 100# 1 0# 1
..and this WAS working for my Obi110.
Then I upgraded to an Obi202. I set up basic configuration and password and got the Obi202 running: both SP1 and SP2 are set up for separate Google Voice accounts, and calls in and out work on both.
Now I try to use that same DISable sequence (i.e., the 2nd one, above) to disable SP1 with the Obi202, as I did with the Obi110. (However, I am doing it slowly/manually, by hand, not using the speed-dial buttons at this point.) When I try to do this, the IVR does confirm that SP1 is disabled, but after I hang up (or hit *), device appears to go through its reboot (which takes a minute or so), and temporarily looks like SP1 light is out/off, and SP2 light stays on: GOOD. But then the unit does some more blinking (network traffic light flashing), and next thing I know, SP1 light comes back on too, and SP1 is RE-ENabled all over again (and I can make calls out and receive calls in on it). It is as if something is overriding my IVR command and forcing SP1 enabled always.
(By the way, I have the same problem with SP2, using 200# commands.)
So, SP1 reverts to Enabled every time, essentially not allowing me to disable it. Why?
This is most frustrating. Am I just missing something simple? Does anyone have any knowledge (or hunches) as to why this might be? The IVR DOES tell me that SP1 is now disabled, and so I hit * and hang up, and i do see the light go out. But within a few minutes, it is right back on again.
I have indeed looked over the Admin Guide, in the section on SIP Service Provider Configuration Options, at
http://www.obihai.com/OBiAdminGuide.htm#_Toc333506073 many times. Maybe I am blind and just missing something obvious?
Would appreciate any help or ideas anyone could provide.
Thanks
-JS