I'm not
registering the SIP on the SP - I'm following instructions from RonR about just enabling the SP with a dummy ProxyServer. This allows my me to use SIP routing like this:
19142961111@mydomain.dyndns.info:5063, or
442032982000@176.192.123.1.
So there is no AuthUserName or password needed - my phone rings on anything sent to that specific 506x port.
This rule has
never let a SIP scanner through:
{(x|xx|xxx|xxxx|xxxxx|xxxxxx):}Is the CallerID only controlled by the place who gives me the DID number(s) - or is their a way to tell the OBI to pass through the number dialed as the caller ID instead of the phone number that called the DID number? If I could get it to do this - I'm back to being able to use the rule below, with a bunch of DID's ringing SP4, and based on the DID dialed, determine what rule to use.
Below would work great if caller ID was showing the DID number called, instead of the persons caller ID that called the DID.
Based on any of my DID(s) called, from ANY number, redial another number: - will only work if I can get the caller ID to show the DID #, not the caller's number:
Voice Services > SP4 Service > X_InboundCallRoute:{>MyDIDNmbr1:sp2(Redial some number via SP2)},
{>MyDIDNmbr2:sp3(Redial some number via SP3)},
{ph}