Started by ascendedmind, July 26, 2018, 02:34:57 PM
Quote from: ascendedmind on July 29, 2018, 11:13:29 AM OMG is #1 the new value? "Press 1 to Enter a New Value"
Quote from: ascendedmind on July 29, 2018, 01:36:41 PM I'm able to disable WAN, but not enable it.Just repeats old value of 22.214.171.12450 & press zero to repeat this information!Pressing 1# to enable does not work to enable. It's stuck at - Press 1 to Enter a New Value
Quote from: ascendedmind on July 29, 2018, 03:42:57 PMFUBAR: "The firmware version is not read out when you press keys to enable access to the onboard management interface via the INTERNET port." Does not work if I enable or disable WAN or use of Internet or WAN port as described very FAQ. Internet or WAN port, results in "The webpage cannot be found" or The requested URL was not found!This should be an easy fix, however it has turned very convoluted.
Quote from: ascendedmind on July 29, 2018, 04:09:56 PMI already did that, several times. Should not typing in the ip address into the browser immediately open the OBihair page? It has not. Even after following the instruction. It must be something simple, causing this issue.Shall I use the WAN port & enable it or Internet port? Remember neither has worked. I did exactly as you previously said. I will repeat again.
Quote from: ascendedmind on July 29, 2018, 05:19:58 PMdrgeoff, if I disable Internet (WAN) port access, does that automatically active internet port access?The WAN port is disabled, shall I turn back on?My OBi202 is plugged into the internet port on OBi202 to WAN port on Medialink Router
Quote from: ascendedmind on July 30, 2018, 07:23:17 AMNot trying to frustrate you, Use A: Leave my connection as is from OBi202 internet port (blue)to WAN port (blue) on Router?Use B: use WAN port (Yellow) from OBi202 to WAN port (blue) on Router?
Quote from: ascendedmind on July 30, 2018, 08:03:20 AMIt says WAN & it's yellow next to Internet colored blue in PDF just like mine is.