Hello,
I have an Obi 202 working with GV and the Anveo 911 service. I need to be able to send and receive faxes. Ideally, I would love to do this from both my computer (W8) and fax (Brother MFC-J630v), but I am OK if it just works with the fax.
I am assuming I need to do these things to get just the fax working.
1. Get another GV account for the fax number
2. Get a service for Callcentric....I think it is the pay as you go service
3. Connect a regular phone line to the back of the Obi and put the other end in the jack on the wall
4. In the room with the fax, connect a phone cord from the wall to the fax
Below is my current setup. I am assuming I need to connect CallCentric to one of the open service ports and the new GV account to the other. What I am not sure is which of these should be listed under phone 2 for Phone Port Configuration Summary. I am also not sure if there is anything else I would need to do.
Thanks,
J
SPI = GV
SP2 not configured
SP3 not configured
Sp4 Anveo E911
BT1 not configured
BT2 not configured
Obliline not configured
phone 1 phone 2
Primary Line for Outgoing calls Route to Sp1 not configured
Phone rings on incoming calls from sp1, sp4 sp4
Voicemail notification alert from Sp1 Blank
Emergency service call routes sp4 sp4