Newbie here... I have a FreePBX Linux setup with multiple extensions and two incoming routes from Flowroute. Just installed a new OBI-202 to hopefully improve CID shown on a Dish connected TV.. Everything seems to work great including FAXing however, the Obi-202 RINGS both analog ports whenever a call is routed to either ATA port by the PBX. Substituting my prior Cisco ATA shows proper signaling of the analog ports. A call to "line-1" rings the ring group associated with "line-1"; calls to "line-2" ring the proper lines... In the OBI-202, I have two (2) SIP setups with two distinct extensions (113 & 114) and both are properly registered with the Linux PBX machine. The ring groups in the PBX are properly configured. My guess at this time is that something is mis-configured in the OBI-202 causing both SIP lines to ring independent of which line was called; it is if they are slaved together... Suggestions on how to configure the OBI-202 to ring the analog phone ports independently/properly would be greatly appreciated. Thanks, BobJ (Clivusmul)